HPE FlexNetwork 5130 EI Series Layer 3-Ip Services Configuration Guide

42
Procedure
1. Enter system view.
system-view
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name
By default, no DHCP address pool exists.
3. Specify WINS servers.
nbns-list ip-address&<1-8>
By default, no WINS server is specified.
This step is optional for b-node. You can specify a maximum of eight WINS servers for such
clients in one DHCP address pool.
4. Specify the NetBIOS node type.
netbios-type { b-node | h-node | m-node | p-node }
By default, no NetBIOS node type is specified.
Specifying BIMS server for DHCP clients
About BIMS server for DHCP clients
Perform this task to provide the BIMS server IP address, port number, and shared key for the clients.
The DHCP clients contact the BIMS server to get configuration files and perform software upgrade
and backup.
Procedure
1. Enter system view.
system-view
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name
3. Specify the BIMS server IP address, port number, and shared key.
bims-server ip ip-address [ port port-number ] sharekey { cipher |
simple } string
By default, no BIMS server information is specified.
Specifying the configuration file for DHCP client automatic
configuration
About configuration file for DHCP client automatic configuration
Automatic configuration enables a device to automatically obtain a set of configuration settings at
startup. The server-based automatic configuration requires the cooperation of the DHCP server and
file server (TFTP or HTTP server). The device uses the obtained parameters to contact the file server
to get the configuration file. For more information about automatic configuration, see Fundamentals
Configuration Guide.
Specifying the configuration file on a TFTP file server
1. Enter system view.
system-view
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English