WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
power from the server by removing the power cord. The front panel Power On/Standby button
does not shut off system power. Portions of the power supply and some internal circuitry
remain active until AC power is removed.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website. Follow the instructions on the website to update the system ROM.
3. Power down the server (Power down the server on page 35).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
• Remove the air baffle.
• If installed, remove the 4LFF midplane drive cage.
9. Remove any components or cables that may prevent access to the TPM connector.
10. Proceed to Installing the TPM board and cover on page 129.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION:
If the TPM is removed from the original server and powered up on a different server, data stored
in the TPM including keys will be erased.
Hardware options installation 129
To Next Page
Loading...
