hpmont HD3N Series - Chapter 5 Operation Instructions; User Password Management

Shenzhen Hpmont Technology Co., Ltd. Chapter 5 Operation Instructions
HD3N Series User Manual V1.1 - 43 -
Restore to factory setting
Set F01.02 = 1 (Restore to factory settings) to restore the values of parameter to factory setting, as
shown in Figure 5-6.
Figure 5-6 Restore to factory setting
Unlock user password
F01.00 = non-zero value, press button ( ) to exit to stop / run display status, or do not
operate within 5 minutes, the user password will be valid and ”LOCK” will be lighting. In this status,
parameters can not be modified.
In “LOCK” status, to modify parameter, user needs to unlock the password. Figure 5-7 takes “00004” as
the user password.
Figure 5-7 Unlock user password
Modify user password
Provided that new password is “02004”, if password haven’t been set, set F00.00 according to Figure
5-8. If password have been set, unlock according to Figure 5-7, then set F00.00 according to Figure 5-8.
Figure 5-8 Modify user password
Clear user password
If password have been set, unlock according to Figure 5-7, then clear F00.00 according to Figure 5-9.
Figure 5-9 Clear user password
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
1.5s
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
1.5s 后
FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM
FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM
FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM FWD
Hz A V RPM
LO/R E
%
LOCKREV
ALM
1.5s
FWD
H z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H
z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H
z A V RPM
LO/R E
%
LOCKREV
ALM
FWD
H
z A V RPM
LO/R E
%
LOCKREV
ALM
5