Documents: documents delivered with the camera, monitoring drawings and
parameters
Skill requirement: ELV engineer
Procedure
Step 1 Remove the front cover of the camera and remove the screws from the front
cover.
Step 2 Remove the inner cover.
Figure 4-55 Removing the inner cover
In the scenario with an SD card, remove the SD card and install it in a new camera.
Step 3 Use a Phillips screwdriver to remove the screws that fasten the camera to its base.
Figure 4-56 Removing the camera base
FusionDC1000A Prefabricated All-in-One Data
Center
Maintenance Guide (IT Scenario) 4 Parts Replacement
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 109
To Next Page
Loading...
