Procedure
Step 1 Open the door of the IC card reader box.
Step 2 Remove the two screws at the bottom of the IC card reader, and remove the front
cover.
Figure 4-59 Removing the front cover
Step 3 Remove the two screws that secure the IC card reader body.
Figure 4-60 Removing screws
Step 4 Remove interconnection terminals from the IC card reader, and remove the IC card
reader body.
Step 5 Remove the two screws from the bottom of the new IC card reader, and remove
the front cover.
Step 6 Reconnect the interconnection terminals, and close the door of the IC card reader
box.
Step 7 On the Authorization Operations tab page, click Synchronize to Device, select
the
modied access control devices, and click Start Synchronization.
Step 8 When Synchronization Status is Synchronization completed for the related
devices, close the Synchronize Access Permission page.
FusionDC1000A Prefabricated All-in-One Data
Center
Maintenance Guide (IT Scenario) 4 Parts Replacement
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 112
To Next Page
Loading...
