Huawei FusionDC1000A - Aisle Sliding Door

Table 3-1 Paint repair
Paint Damage Tools and Materials Procedure Description
Slight scratch (steel
base material not
exposed)
Spray paint or paint,
brush (required for
repainting a small
area), ne sandpaper,
anhydrous alcohol,
cotton cloth, painting
gun (required for
repainting a large
area)
Steps 1, 2, and 4 1. For the color of the
nish coat
(polyurethane
paint), see the
delivered color
palette and
pantone No.
specied on it.
2. For a few smudges,
scratches or rusts,
Huawei
recommends
manual paint
spraying or paint
brushing.
3. For many scratches
or large-area
smudges and rusts,
use a painting gun
to spray paint.
4. The paint coating
should be thin and
even. Paint drops
are prohibited on
the coating. The
surface should be
smooth.
5. Leave the repainted
area for about 60
minutes before
performing any
further operation.
Smudges and rust that
cannot be wiped o
Deep scratch (primer
damaged, steel base
material exposed)
Spray paint or paint,
zinc-rich primer, brush
(required for
repainting a small
area), ne sandpaper,
anhydrous alcohol,
cotton cloth, painting
gun (required for
repainting a large
area)
Steps 1, 2, 3, and 4
LOGO and pattern
damage
Seek help from Huawei headquarters for a detailed painting solution.
Frontline personnel can turn to local advertisement coating suppliers.
Dent
1. If a dent is less than 100 mm
2
in area and less than 3 mm in depth,
ll the dent with Poly-Putty base and then perform the same
operations as those for processing deep scratches.
2. If a dent is greater than 100 mm
2
in area or greater than 3 mm in
depth, ask the local supplier for an appropriate repainting solution.
Procedure
Step 1 Gently polish damaged areas using ne sandpaper to remove smudges or rust.
FusionDC1000A Prefabricated All-in-One Data
Center
Maintenance Guide (IT Scenario) 3 Routine Maintenance
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 21