Huawei FusionModule500 V100R021C10 - Commissioning Sensors; Setting and Adding a Smoke Detector (Connected to an AI;DI Port on the ECC800-Pro)

Path Parameter Setting
Communications Port Select COM4 from the
drop-down list box.
NOTE
The setting example
indicates that the
UPS2000G is connected to
the COM4 port on the
ECC800-Pro. If the
UPS2000G is connected to
another port, enter the
number of the connected
port.
Device Address In this example, Device
Address is set to 1.
During actual
conguration, set the
device address for the
UPS2000G-L based on
the actual situation.
3. Click Test Connect to check whether the UPS2000G-L connects to the
ECC800-Pro properly.
● If the connection succeeds, click
Conrm. The connected devices are displayed
in the Number of connected devices list.
● If the connection fails, check whether the UPS2000G is properly connected to
the ECC800-Pro, whether the UPS2000G and ECC800-Pro are running properly,
and whether the parameter settings are consistent with the UPS2000G
parameters.
----End
5.3.6 Commissioning Sensors
5.3.6.1 Setting and Adding a Smoke Detector (Connected to an AI/DI Port on
the ECC800-Pro)
If a smoke detector is installed, perform the following steps to congure it.
Context
If the detector is prefabricated, only check its settings.
Procedure
Step 1 Set smoke detector parameters.
1. Log in to the ECC800-Pro WebUI as an administrator.
FusionModule500 Smart Mini Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 125