5. Click Save. After the camera NTP synchronization function is enabled, the
camera, after being connected to the server, will automatically time-
synchronize with the server.
Figure 5-30 Conguring camera NTP synchronization
Step 6 Create a user.
When connecting to the IVS1800 on the NetEco, you need to log in to the VCN as
a non-admin user.
1. Log in to the OMU portal as the admin user.
2. Choose User Management > Add User.
When creating a user, you can select Enable account validity period and set Valid from
and Valid to to set the account validity period for the created user.
3. Set Multi-point logins to a value greater than 2.
4. On the User List page, click Permission Settings next to the new user, select
the cameras to be browsed and queried, obtain the documents delivered with
the device or by referring to the "Reference Documentation" section, set other
parameters, and click Save.
----End
5.3.11.3 Setting Parameters on the iClient
Prerequisites
The network communication between the IVS1800 and the camera is normal.
Procedure
Step 1 Install the iClient.
1. Download the iClient.
You can obtain the iClient in either of the following ways:
FusionModule500 Smart Mini Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 156
To Next Page
Loading...