Huawei FusionModule500 V100R021C10 - Optional) Neteco Management; Neteco6000 Management; Connecting the Communications Cable; Setting Neteco Parameters

7. Click Finish.
8. Preview live video. On the iClient home page, click Live and drag a camera to
the live video pane. If the live video can be properly played, the camera is
successfully connected.
Step 3 Congure a video recording plan.
1. Choose System Management > Device Management > Micro Edge on the
iClient home page.
2. Right-click an IVS1800 and choose Storage Management.
3. Click the Server Recording tab. The tab page for conguring a server-based
recording plan is displayed.
4.
Congure a video recording plan.
NO TE
If you set the recording plan policy to All, you do not need to set the recording plan time.
5. Click Save.
----End
5.3.12 (Optional) NetEco Management
5.3.12.1 NetEco6000 Management
5.3.12.1.1 Connecting the Communications Cable
Procedure
Step 1 Connect the communications cable to the WAN1 port on the ECC800-Pro.
Figure 5-36 Connecting the communications cable
----End
5.3.12.1.2 Setting NetEco Parameters
When the smart module can be connected to the NetEco, perform the following
steps to congure parameters.
Procedure
Step 1 Apply for a xed IP address to the equipment room network administrator.
FusionModule500 Smart Mini Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 160