Figure 5-33 Adding a device
– If the iClient and IVS1800 are deployed in the same LAN, set Address to the
internal IP address of the IVS1800. If the iClient is installed on an external network
and the IVS1800 is deployed in the LAN, set Address to the external IP address of
the IVS1800.
– When the IVS1800 is added to the iClient by the admin user, the iClient checks
whether the login password of the admin user has been set. If the password is not
set, log in to the OMU portal to set the password.
6. Click Finish to go to the iClient.
Step 2 Add a camera. For details, see the documentation delivered with the device or
obtain the documentation by referring to the "Reference Documentation" section.
View the corresponding section.
1. On the home page of the iClient, choose System Management > Device
Management > Device Management > Micro Edge.
2. Right-click an IVS1800 and choose Camera Access.
3. Select Auto Batch Access and click Start.
4. Set the IP address segment.
FusionModule500 Smart Mini Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 158
To Next Page
Loading...