Huawei FusionModule500 V100R021C10 - Page 43

Item Specications
4G Supports the 4G module, SMS sending, and 3G
communication, and provides a standard SIM card slot.
1. China: 2G and 4G networks support China Unicom or
China Mobile SIM cards, and 3G networks support only
China Unicom SIM cards.
2. Outside China: Select SIM cards according to the following
wireless modes and frequency bands:
● 4G: wireless mode (FDD-LTE and TDD-LTE), coverage
frequency band (B1, B3, B5, B7, B8, and B20)
● 3G: wireless mode (WCDMA), coverage frequency bands
(B38, B40, and B41)
● 2G: wireless mode (GSM), coverage frequency band
(900/1800 MHz)
NOTE
The prerequisite for using a SIM card is that the site has signal
coverage.
USB ● Supports USB 2.0 and 5 V, 1 A power supply.
● After installing the WiFi module, connect the WiFi module
to the ECC800-Pro using the app on the mobile phone or
PAD to view the basic information about the smart
module, such as layout, resources, energy eciency,
environment, and alarms.
● You can insert a USB ash drive to export historical data
and conguration les and import conguration les.
SW button ● Restores the default IP address, factory settings, and user
information.
● Supports RF_Z networking.
Table 3-13 ECC800-Pro RF_Z parameters
Item
Specications
RF_Z Operation
Frequency
2405–2480 MHz
RF_Z EIRP (max.) 8 dBm
FusionModule500 Smart Mini Data Center
User Manual 3 System Architecture
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 34