iManager NetEco 6000
Device Installation and Commissioning Guide
4 Connecting Monitoring Cables to Devices
Copyright © Huawei Technologies Co., Ltd.
Figure 4-38 Connecting cables to the double door interlock
Connecting the Power Cable to the Access Controller
The access controller is powered by 220 V power supply. The power module is installed
inside the access controller. The access controller can obtain power from a power supply
outside the equipment room.
Strip the cable, install the connector (BOM number: 14170096), and connect the wires
respectively to the L, N, and PE wiring terminals on the terminal block in the access
controller power module, as shown by (1) in Figure 4-39. Route the other end of the cable
along the cable trough inside the access controller and then out of the cable outlet, and
connect it to the power supply to receive power.
Pay attention to the polarity when connecting cables.
To Next Page
Loading...
Need help?
General