iManager NetEco 6000
Device Installation and Commissioning Guide
Copyright © Huawei Technologies Co., Ltd.
Indicates the password for
logging in to the IVS client.
Click Set Password and
configure the password on
the displayed page.
If the password does not
comply with the rules,
please change the password
on device.
NOTE
The default password for
VCN500 is Change_Me.
Indicates the transmission
protocol. Set the
transmission protocol in the
same way as setting the
protocol using eSpace IVS.
The path for setting the
transmission protocol is as
follows: Para. Setting >
Local Parameter >
Transmission protocol.
The transmission protocol
can be UDP or TCP.
Step 4 Click Test after configuring parameters.
During the first test, the page turns blank. Wait 30s.
If the test fails, a message indicating a connection failure is displayed.
Step 5 Click Apply.
----End
6.3.2.6 Registering with the OCX Plug-in
Only after you register with the OCX plug-in, you can play videos recorded by the camera on
the NetEco in real time.
Procedure
Step 1 Open Internet Explorer and choose Tools > Internet Options.
Step 2 Click Security, as shown in Figure 6-24.
To Next Page
Loading...
Need help?
General