iManager NetEco 6000
Device Installation and Commissioning Guide
4 Connecting Monitoring Cables to Devices
Copyright © Huawei Technologies Co., Ltd.
Figure 4-54 RS485 port
(1) COM1 port (RS485 supported)
(2) COM2 port (RS485 supported)
Step 2 Connect the other end of the network cable to the COM port on the ECC500 collector.
----End
4.3.7.2 Connecting the UPS5000-A Monitoring Cable
Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of a network cable to the COM port of the UPS5000-A.
To Next Page
Loading...
