Huawei iManager NetEco 6000 - Installing a Region-Type Water Sensor

iManager NetEco 6000
Device Installation and Commissioning Guide
3 Installing Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
28
Figure 3-19 Installing the ambient temperature and humidity sensor

For details about how to install an ambient temperature and humidity sensor and connect its cables,
see shipped documents.

Connect cables to an ambient temperature and humidity sensor before installation.
----End
3.6.6 Installing a Region-type Water Sensor
Context

A water sensor consists of a water detection cable, water detector, and conversion cable.
The water detection cable is laid out on the floor, connecting to the water detector placed
near the collector by the conversion cable.