iManager NetEco 6000
Device Installation and Commissioning Guide
Copyright © Huawei Technologies Co., Ltd.
Figure 7-36 Removing a bottom plate
Step 2 Remove the original bottom plate, as shown by (4) in Figure 7-36.
Step 3 Take out the bottom plate of the new card reader with a keypad and secure it.
Step 4 Connect the cable.
Step 5 Secure the card reader with a keypad to the bottom plate.
Step 6 Choose System > Configuration Management > Data Center Planning from the main
menu. The Data Center Planning window is displayed.
Step 7 Select the new card reader with a keypad, and click Connection Test. When Connection
success is displayed, the replacement is complete.
----End
7.2.7.7 Replacing a Fingerprint and Card Reader with a Keypad
Prerequisites
Recommended tool: Phillips screwdriver
A fingerprint and card reader with a keypad needs to be replaced.
A spare fingerprint and card reader with a keypad of the same model is available and
functional.
To Next Page
Loading...
Need help?
General