Huawei iManager NetEco 6000 User Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
171
Parameter
Description
Timeout period
Timeout duration for connection test (set to 3s by default)
Table 6-16 SNMP v3 device parameter description
Parameter
Description
Name
Device name
IP Address
Set this parameter to the device IP address.
Port
Set this parameter to the port number of the device. (set to 161 by
default)
Security Name
Set this parameter to the user name added in SNMPv3 on the
WebUI of the device.
Authentication
Protocol
Set this parameter to the authentication protocol set on the device.
The default selection is SHA.
Support SHA and MD5 agreement.
Authentication
Password
Set this parameter to the SHA or MD5 password set on the device.
Privacy Protocol
Set this parameter to the privacy protocol set on the device. The
default selection is AES.
Support CBC_DES, AES128, AES192, and AES256 agreement.
Privacy Password
Set this parameter to the AES or DES password set on the device.
NOTE
You are advised to set Authentication Password and Privacy Password to
different values.
Timeout period
Timeout duration for connection test (set to 3s by default)
Step 7 Click Connection Test to start the connection test.
Step 8 After the connection test is successful, click in the toolbar to save the device
information.
For UPS, if a battery monitor unit (BMU) is connected, the BMU will be automatically created.
----End

Huawei iManager NetEco 6000 Specifications

General

Brand	Huawei
Model	iManager NetEco 6000
Category	Server
Language	English