Huawei iManager NetEco 6000 - Page 191

iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
180
Figure 6-41 Configuring RPDU SNMP parameters
Table 6-20 SNMP v1/v2 device parameter description
Parameter
Description
Name
Device name
IP Address
Set this parameter to the device IP address.
Port
Set this parameter to the port number of the device. (set to 161 by
default)
Read Community
Set this parameter to the read community set on the device. (set to
public by default)
Modifying community per three months is advised.