Huawei iManager NetEco 6000 - Page 223

iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
212
Figure 6-71 Configuring parameters for a NTC
Table 6-29 Parameter description
Parameter
Description
Name
Device name
IP address
Set this parameter to the IP address of the collector to which the
device is connected.
Port
The NTC port number is the same as the ECC port number for the
independent deployment AI/DI unit. Fill in the actual value by
referring to Setting RS485 Parameters for the ECC500 V6 Collector.
Device address
The device address is configured using the DIP switch of the
independent deployment AI/DI unit.