Huawei iSitePower-M - Mechanical Safety and Ladders

CA UTION
If a battery leaks or bulges, do not transport the battery. In this case, contact a
battery recycling company.
2.6 Mechanical Safety
Using Ladders
● Use wooden or
berglass ladders when you need to perform live working at
heights.
● When a step ladder is used, ensure that the pull ropes are secured and the
ladder is held
rm.
● Before using a ladder, check that it is intact and conrm its load bearing
capacity. Do not overload it.
● Ensure that the wider end of the ladder is at the bottom, or protective
measures have been taken at the bottom to prevent the ladder from sliding,
● Ensure that the ladder is securely positioned. The recommended angle for a
ladder against the
oor is 75 degrees, as shown in the following gure. An
angle rule can be used to measure the angle.
● When climbing a ladder, take the following precautions to reduce risks and
ensure safety:
– Keep your body steady.
– Do not climb higher than the fourth rung of the ladder from the top.
– Ensure that your body's center of gravity does not shift outside the legs
of the ladder.
Drilling Holes
When drilling holes into a wall or ground, observe the following safety
precautions:
● Wear goggles and protective gloves when drilling holes.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 2 Safety Precautions
Issue 02 (2021-12-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 10