Installation Manual
Quidway R2600/3600 Series Modular Routers
Chapter 5
Startup and Configuration
5-5
II. Powering on the router
Powering on the router as follows:
z
Switch on the power supply for the router.
z
Turn on the switch of the router (set the switch of the router to ON).
III. Power-on Check
After the router is powered on, please check:
z
That the ventilation system works normally
Method: When the router is powered on, you should be able to hear the running of the
fan. When placing your hand near the vent of the router, you should be able to feel
the
flow of the air.
z
That the indicator on the front panel of the router is normal
Method: when the router is powered on, the POWER indicator on the front panel is on.
z
That the configuration terminal displays information normally.
Method: when the router is powered on, the terminal will show such system information
as the version of the router.
5.1.3 Starting Router
I. Starting BOOT
When the router is powered, it will run the BOOTROM program first. The screen on the
terminal will show the following system information:
Be aware that the BOOTROM terminals of different versions may have slightly different
interfaces.
Quidway starts booting
******************************************
* *
Quidway Series Router Boot Rom, V4.10
* *
******************************************
Copyright(C) 1999-2001 by Huawei Technologies Co., Ltd.
Now Testing Memory...OK!
64M bytes DRAM
8192K bytes flash memory
Press Ctrl-B to enter Boot Menu ..........
Press
<Ctrl+B>
, and the system will access the BOOT menu. Otherwise the system
will initialize.
Note:
Within a few seconds after the appearance of “Press Ctrl-B to enter Boot Menu...” it is necessary to press
<Ctrl+B> to access the BOOT menu; otherwise, the system will begin the program decompression
process. To access the BOOT menu after the program decompression process begins; you have to restart
the router.
To Next Page
Loading...
Need help?
General
