Huawei SmartAX MA5600T User Manual

huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftto_voip outbound traffic-table
name
ftto_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftto_voip outbound traffic-table
name
ftto_voip
3. Enable the ARP proxy function.
Voice media streams for different users of the same S-VLAN fail to interchange because
the service ports of the smart VLAN are isolated from each other. Therefore, the ARP proxy
function needs to be enabled on the OLT.
huawei(config)#arp proxy enable
huawei(config)#interface vlanif 300
huawei(config-if-vlanif300)#arp proxy enable
huawei(config-if-vlanif300)#quit
4. Save the data.
huawei(config)#save
Step 2 Configure ONU voice service profiles.
ONU voice service profiles include the interface common profile, SIP agent profile, SIP service
data profile, POTS port profile, and digitmap profile.
l Interface common profile: saves common attributes of an ONU voice interface, including
the fax mode, fax/modem negotiation mode, and priority of the coding and decoding mode.
l SIP agent profile: saves the SIP agent information about an ONU, including the IP address
and domain name of the SIP agent server and attributes of media packets and signaling
packets.
l SIP service data profile: saves the data information about ONU voice services, including the
rights of the call waiting service, three-party service, call forwarding service, and call holding
service.
l POTS port profile: saves physical attributes of a POTS port on an ONU, including the
impedance, transmitting gain, receiving gain, and signaling type of the POTS port.
l Digitmap profile: saves the digitmap information about an ONU, including the timeout time
of the digitmap timer and the digitmap format.
1. Configure an interface common profile.
Run the display ont-mg-attribute-profile command to query the existing interface
common profile in the system. If the existing interface common profile in the system does
not meet the requirements, run the ont-mg-attribute-profile add command to add an
interface common profile.
In this example, the default interface common profile, namely interface common profile 1
is used.
2. Configure an SIP agent profile.
Run the display ont-sipagent-profile command to query the existing SIP agent profile in
the system. If the existing SIP agent profile in the system does not meet the requirements,
run the ont-sipagent-profile add command to add an SIP agent profile.
Create SIP agent profile 2, set the IP address of the SIP server to 200.200.200.200, and use
default values for other parameters.
huawei(config)#ont-sipagent-profile add profile-id 2 proxy-server
200.200.200.200
3. Configure an SIP service data profile.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1171

Huawei SmartAX MA5600T Specifications

General

Brand	Huawei
Model	SmartAX MA5600T
Category	Control Unit
Language	English