4. Add the service port.
To add the service port, run the service-port command. Note that the VPI and VCI values
set during the execution of the service-port command must be the same as those on the
modem.
The QinQ VLAN supports the PVC-priority scheduling policy only. In this case, select the
profile that supports PVC-priority policy.
huawei(config)#traffic table ip index 7 cir off priority 0 priority-policy
local-Setting
huawei(config)#service-port vlan 50 shdsl mode atm 0/5/15 vpi 0 vci 35 rx-cttr
7 tx-cttr 7
Step 8 Save the data.
huawei(config)#save
----End
5.8 Verification
All services configured on all DSLAMs run in the normal state.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 5 Configuration Example of MSTP Subtending Network
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
487
To Next Page
Loading...
Need help?
General
