5. After the multicast service is provisioned, the user can watch ordered multicast
programs.
----End
16.3.2 L2VPN Enterprise Service Networking
In L2VPN enterprise service networking, an MA5633 connects to cable modems (CMs) through
radio frequency (RF) ports, and the CMs connect to switches to provide the L2VPN service for
users. This section describes how to configure the optical line terminal (OLT) and the MA5633
to provision the L2VPN service.
NOTE
Configuration procedures are the same for IPv6 and IPv4 networks except in "onfigure Dynamic Host
Configuration Protocol (DHCP) rela" and "onfigure a route".
16.3.2.1 Service Requirements and Usage Scenario
Service Requirements
An enterprise requires the provisioning of the L2VPN service.
Usage Scenario
As shown in Figure 16-6, MA5633 is deployed on an optical node and cable modems (CMs)
are deployed at enterprises. The CMs connect to radio frequency (RF) ports on the MA5633
through cables.
l A CM provides the enterprise service through a switch, which connects to enterprise users.
l Enterprise users access the Internet through Dynamic Host Configuration Protocol (DHCP)
dialup.
Figure 16-6 L2VPN enterprise service networking
16.3.2.2 Configuration Process
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1711
To Next Page
Loading...
Need help?
General
