Configur
ation
Object
Step Description
MA5633 Configure radio frequency (RF) port
parameters.
Radio frequency (RF) port
parameters define the frequency
spectrum range for signal
transmission and modulation mode.
The configuration of RF port
parameters implements data service
transmission over cables.
Configure the high-speed Internet
(HSI) service.
None
Configure the VoD service. None
Configure the broadband TV (BTV)
service.
None
Configure the dynamic PacketCable
service.
None
Verify the configured services. A D-CMTS supports multiple
remote service verification methods.
This allows commissioning and
configuration engineers to remotely
verify services.
1. A DHCP dialup emulation test
checks whether the D-CMTS can
communicate with the DHCP
server and verifies CM DHCP
configurations on the DHCP
relay, proxy, and server.
2. The status of a CM can be
queried. Based on the
information, you can determine
whether the CM is online.
16.4.1.3 Configuring DHCP Relay
This section describes how to configure Dynamic Host Configuration Protocol (DHCP) relay
so that cable modems (CMs) can obtain IP addresses in different network segments.
Prerequisites
The upper-layer router, DHCP server, and Trivial File Transfer Protocol (TFTP) server of an
optical line terminal (OLT) have been configured.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1736
To Next Page
Loading...
Need help?
General
