Configuration File
vlan 10 smart
multicast-vlan 10
igmp match mode disable
igmp match group ip 224.1.1.1 to-ip 224.1.1.2
igmp uplink-port 0/19/0
igmp mode proxy
quit
vlan 20 smart
igmp match mode disable
igmp match group ip 224.1.1.3 to-ip 224.1.1.4
igmp uplink-port 0/19/0
igmp mode proxy
quit
interface vdsl 0/2
deactivate 1
activate 1 template-index 1
alarm-config 1 1
quit
interface vdsl 0/4
deactivate 1
activate 1 template-index 1
alarm-config 1 1
quit
port vlan 10 0/19 0
port vlan 20 0/19 0
service-port 100 vlan 10 vdsl mode ptm 0/2/1 rx-cttr 2 tx-cttr 2
service-port 101 vlan 20 vdsl mode ptm 0/4/1 rx-cttr 2 tx-cttr 2
btv
igmp user add service-port 100 auth log enable
igmp user add service-port 101 auth log enable
multicast-vlan 10
igmp multicast-vlan member service-port 100
multicast-vlan 20
igmp multicast-vlan member service-port 101
quit
save
3.3 Example: Configuring the VoIP Service
This topic describes how to configure the H.248-based, MGCP-based, and SIP-based VoIP
services respectively.
3.3.1 Example: Configuring the VoIP Service (H.248-based)
This topic describes an example for configuring the H.248-based VoIP service.
Service Requirements
In an office located in China, the MA5600T/MA5603T/MA5608T that adopts the H.248 protocol
is newly deployed. Data plan and configuration, however, are not performed on the MGC
(softswitch) connected to the MA5600T/MA5603T/MA5608T. The MA5600T/MA5603T/
MA5608T is required to provide the following VoIP services:
l The common phone services are provisioned to 32 users (phones 0-31).
l The polarity-reversal accounting is adopted.
Figure 3-9 shows an example network for configuring the H.248-based VoIP service.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3 Configuring the DSLAM Services
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
301
To Next Page
Loading...
Need help?
General
