ip address 192.168.1.20 24
mpls
quit
ospf 1
area 200
network 192.168.1.0 0.0.0.255
network 5.5.5.5 0.0.0.0
return
config
interface tunnel 20
tunnel-protocol mpls ip
destination 7.7.7.7
quit
tunnel-policy atmpw-plcy
tunnel select-seq ip load-balance-number 1
quit
pw-para 20
peer-address 7.7.7.7
pw-type atm nto1 vcc
control-word
max-atm-cells 4
max-encapcell-delay 10
tnl-policy atmpw-plcy
quit
traffic table ip index 20 cir off color-policy cos priority user
-cos 1 priority-policy tag-in-package
traffic table ip index 21 cir off color-policy cos priority user
-cos 4 priority-policy tag-in-package
traffic table ip index 22 cir off color-policy cos priority user
-cos 5 priority-policy tag-in-package
multi-service-port vlan aoe board 2 vpi 0 vci 35 inbound traffi
c-table index 20 outbound traffic-table index 20
multi-service-port vlan aoe board 3 vpi 0 vci 35 inbound traffi
c-table index 21 outbound traffic-table index 21
multi-service-port vlan aoe board 4 vpi 0 vci 35 inbound traffi
c-table index 22 outbound traffic-table index 22
multi-pw-ac-binding pvc board 2 vpi 0 vci 35 from-outvpi 0 outvci 32
from-invpi 1 invci 32 pw 20 static transmit-label 8450 receive-label 8460
multi-pw-ac-binding pvc board 3 vpi 0 vci 35 from-outvpi 0 outvci 33
from-invpi 1 invci 33 pw 21 static transmit-label 8451 receive-label 8461
multi-pw-ac-binding pvc board 4 vpi 0 vci 35 from-outvpi 0 outvci 34
from-invpi 1 invci 34 pw 22 static transmit-label 8452 receive-label 8462
wred-profile index 5 green low-limit 100 high-limit 100 discard-probability
0 yellow low-limit 50 high-limit 80 discard-probability 100
queue-wred queue0 5 queue1 5 queue2 5 queue3 5 queue4 5 queue5 5
queue6 5 queue7 5
cos-remark cos1 0 cos4 2 cos5 5
cos-queue-map cos0 1 cos1 1 cos2 4 cos4 4 cos5 5
mpls car-pw 20 cir 12288
mpls car-pw 20 cir 30720
mpls car-pw 20 cir 6144
4.3.2 Example: Configuring the ATM PWE3 to Achieve emulated
ATM Services on the MPLS Network
ATM PWE3 is mainly used in ATM network reconstruction. When the MPLS protocol is
deployed for the transmission network and the ATM network evolves to the MPLS network,
PWE3 encapsulation is recommended.
Service Requirements
l The xDSL service board (or AIUG board) of the MA5600T/MA5603T/MA5608T is used
to provide the ATM service.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4 Configuration Example of the Private Line Service
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
408
To Next Page
Loading...
Need help?
General
