1.4.1.2 Commissioning Outband Management (SNMP V3)
This topic describes how to implement the outband network management on the MA5600T/
MA5603T/MA5608T using the local maintenance Ethernet port (outband network management
port). This enables the U2000 to maintain the MA5600T/MA5603T/MA5608T using this
management channel. In the outband network management mode, a non-service channel is used
to transmit the management information. With the use of the non-service channel, the
management channel is separated from the service channel, which is more reliable than in the
inband network management mode.
Service Requirements
In the network as shown in Figure 1-55, the service requirements are as follows:
l The MA5600T/MA5603T/MA5608T provides the outband network management channel
through the local maintenance Ethernet port.
l A static route is used between the MA5600T/MA5603T/MA5608T and the U2000.
l SNMP V3 is used (more reliable than V1 and V2, providing network security and access
control management functions).
Figure 1-55 Example network for the outband network management
U2000
10.10.1.10/24
10.50.1.10/24
10.50.1.1/24
Router
Access node
Figure 1-56 shows the flowchart for commissioning the outband network management on the
device.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
143
To Next Page
Loading...
Need help?
General
