-------------------------------------------------------------------------
-----
Run the display clock mode command to query the clock working mode. Ensure that
the clock daughter board works in tracing mode.
huawei(config)#display clock mode
Clock manage-mode:Third-mode
Clock subboard work-mode:Tracing
l Configure a clock on the ONU.
1. Configure the GPON line clock as the system clock.
The system clock of the OLT is delivered to the ONU through the GPON port on the
OLT, achieving clock synchronization between the OLT and the ONU.
a. Run the clock source command to configure the clock recovered from the GPON
upstream port as the system clock of the ONU.
b. Run the clock priority command to configure the priority of the clock source.
huawei(config)#clock source 0 0/0/1
Clock source set succeeded
huawei(config)#clock priority system 0
2. Configure the system clock as the transmit clock for an E1 port.
a. Run the interface tdm command to enter the E1 port configuration mode.
b. Run the tx clock or port portid udt system command to configure the system
clock as the transmit clock of the port.
c. Run the display port state command to query the transmit clock of the E1 port.
huawei(config)#interface tdm
huawei(config-if-tdm-)#port 0 udt system
huawei(config-if-tdm-)#display port state 0
---------------------------------------
Port : 0
State : normal
Mode : UDT
Code : HDB3
Looptype : -
Timeslot : -
Clock : system
CRC4 : -
Signaling : -
ESF : -
Impedance : 120 Ohm
---------------------------------------
3. Query configurations and the status of the system clock source.
Run the display clock source command to query configurations and the status of the
system clock source.
huawei(config-if-tdm-)#quit
huawei(config)#display clock source
---------------------------------------------------------------
Index Config Type Source State Priority Output
---------------------------------------------------------------
0 YES line 0/0/1 Normal 0 YES
1 NO -- -/ -/ - --- --- ---
2 NO -- -/ -/ - --- --- ---
3 NO -- -/ -/ - --- --- ---
4 NO -- -/ -/ - --- --- ---
5 NO -- -/ -/ - --- --- ---
6 NO -- -/ -/ - --- --- ---
7 NO -- -/ -/ - --- --- ---
8 NO -- -/ -/ - --- --- ---
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1424
To Next Page
Loading...
Need help?
General
