l Add an ONU offline: If the password or SN of an ONU is obtained, you can run
the ont add command to add the ONU offline.
l Automatically find an ONU: If the password or SN of an ONU is unknown, run
the port ont-auto-find command in the GPON mode to enable the ONU auto-find
function of the GPON port. Then, run the ont confirm command to confirm the
ONU.
To add an ONU offline, do as follows:
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#ont add 1 1 sn-auth 48575443E6D8B541 snmp ont-
lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
To automatically find an ONU, do as follows:
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#port 1 ont-auto-find enable
huawei(config-if-gpon-0/3)#display ont autofind 1
//After this command is executed, the information about all ONUs
connected to
//the GPON port through the optical splitter is displayed.
------------------------------------------------------------
Number : 1
F/S/P : 0/3/1
Ont SN : 48575443E6D8B541
Password :
VenderID : HWTC
Ont Version : MA5621
Ont SoftwareVersion : V800R310C00
Ont EquipmentID : SmartAX MA5621
Ont autofind time : 2011-09-10 11:20:16
------------------------------------------------------------
huawei(config-if-gpon-0/3)#ont confirm 1 ontid 1 sn-auth 48575443E6D8B541
snmp ont-lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
NOTE
If multiple ONUs of the same type are connected to a port and the same line profile or service profile
is bound to the ONUs, you can add ONUs in batches by confirming the auto-found ONUs in batches
to simplify the operation and increase the configuration efficiency. For example, the preceding
command can be modified as follows:
huawei(config-if-gpon-0/3)#ont confirm 1 all sn-auth snmp ont-lineprofile-id 10 desc
MA5621_0/3/1_lineprofile10.
5. Confirm that the ONU goes online normally.
After an ONU is added, run the display ont info command to query the current status of
the ONU. Ensure that Control flag of the ONU is active, Run State is online, Config
state is normal, and Match state is match.
huawei(config-if-gpon-0/3)#display ont info 1 1
---------------------------------------------------------------------
F/S/P :
0/3/1
ONT-ID :
1
Control flag : active //Indicates that the ONU is
activated.
Run state : online //Indicates that the ONU already goes online
normally.
Config state : normal //Indicates that the configuration status
of the ONU is normal.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1801
To Next Page
Loading...
Need help?
General
