Huawei SmartAX MA5600T User Manual

Trying 192.168.50.2 ...
Connected to 192.168.50.2 ...
>>User name:root
>>User password: //It is not displayed on the console.
2. Configure the dual PON ports upstream mode.
For GPON type C single-homing protection, set the dual PON ports upstream mode to
Active-standby uplink mode.
huawei(config)#pon uplink-mode active-standby
3. Configure a traffic profile.
The same port is used for transmitting power distribution site information and GOOSE
packets. Therefore, the 802.1p priority of each service needs to be set. The priority of power
distribution site information is lower than that of GOOSE packets. Set the traffic profile
index of power distribution site information to 10 and the priority to 1; set the traffic profile
index of GOOSE packets to 11 and the priority to 5.
huawei(config)#traffic table ip index 10 cir off priority 1 priority-policy
local-Setting
Create traffic descriptor record
successfully
------------------------------------------------
TD Index :
10
TD Name : ip-traffic-
table_10
Priority :
1
Copy Priority :
-
CTAG Mapping Priority:
-
CTAG Default Priority:
0
Priority Policy : local-
pri
CIR :
off
CBS :
off
PIR :
off
PBS :
off
Color Mode : color-
blind
Referenced Status : not
used
------------------------------------------------
huawei(config)#traffic table ip index 11 cir off priority 5 priority-policy
local-Setting
Create traffic descriptor record
successfully
------------------------------------------------
TD Index :
11
TD Name : ip-traffic-
table_11
Priority :
5
Copy Priority :
-
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1827

Huawei SmartAX MA5600T Specifications

General

Brand	Huawei
Model	SmartAX MA5600T
Category	Control Unit
Language	English