Procedure
Step 1 Configure GPON ONU profiles.
1. Configure a DBA profile.
huawei(config)#dba-profile add profile-name fttb_dba type3 assure 8192 max
20480
2. Configure an ONU line profile.
huawei(config)#ont-lineprofile gpon profile-id 10 profile-name fttb(c)
huawei(config-gpon-lineprofile-10)#tcont 4 dba-profile-name fttb_dba
huawei(config-gpon-lineprofile-10)#gem add 11 eth tcont 4 cascade on
huawei(config-gpon-lineprofile-10)#gem add 12 eth tcont 4 cascade on
huawei(config-gpon-lineprofile-10)#gem add 13 eth tcont 4 cascade on
huawei(config-gpon-lineprofile-10)#gem mapping 11 0 vlan 8
huawei(config-gpon-lineprofile-10)#gem mapping 12 1 vlan 1001
huawei(config-gpon-lineprofile-10)#gem mapping 13 2 vlan 200
huawei(config-gpon-lineprofile-10)#commit
huawei(config-gpon-lineprofile-10)#quit
3. (Optional) Add an alarm profile.
In this example, the default alarm profile is used and therefore the configuration of the
alarm profile is not required.
Step 2 Add an ONU to an OLT.
Assume that the ID of GPON port 0/2/1 is 1, SN is 32303131B39FD641, management mode is
SNMP, and the bound line profile is fttb(c). Connect the ONU to such a GPON port through the
optical splitter.
There are two modes to add an ONT: add an ONT offline and confirm an automatically
discovered ONU.
l Add an ONU offline.
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#ont add 1 ontid 1 sn-auth 32303131B39FD641
snmp ont-lineprofile-name fttb(c)
l Confirm an automatically discovered ONU.
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#port 1 ont-auto-find enable
huawei(config-if-gpon-0/2)#display ont autofind 1
huawei(config-if-gpon-0/2)#ont confirm 1 ontid 1 sn-auth 32303131B39FD641
snmp ont-lineprofile-name fttb(c)
1. (Optional) Bind the alarm profile to the ONU.
In this example, default alarm profile 1 is used and therefore the configuration of the alarm
profile is not required.
Step 3 Check the ONU status.
After an ONU is added, run the display ont info command to query the current status of the
ONU. Ensure that Config flag of the ONU is active, Run State is online, and Config state is
normal.
huawei(config-if-gpon-0/2)#display ont info 1 1
---------------------------------------------------------------------
F/S/P : 0/2/1
ONT-ID : 1
Control flag : active //The ONU is activated.
Run state : online //The ONU is online.
Config state : normal //The ONU configurations are recovered
normally.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1894
To Next Page
Loading...
Need help?
General
