The DHCPv6 option18 and option37 functions can be enabled or disabled at two levels. This
function takes effect only when it is enabled at both levels.
1. Global level: Run the dhcpv6 option enable command in global config mode.
2. VLAN level: Run the dhcpv6 option enable command in VLAN service profile mode.
Device Management Data Planning
Device management data planning includes the management channel and IP address planning.
The management channel for IPv6 and IPv4 services are the same.
Planning Device or Service Solution Introduction
Management
channel
OLT The device management uses single-tagged VLANs
on the entire network.
ONU The device management uses single-tagged VLANs
on the entire network.
HGW Single-tagged S-VLANs are used as management
VLANs for all HGWs that need to be managed by
the iTMS.
The management VLANs for HGWs can be
allocated to an entire network, an OLT, a PON
board, or a PON port to identify services and
physical locations. It is recommended that you set
different HGW management VLANs for the OLTs
connected to one SR to avoid an excessively large
broadcast domain of the SR and convergence
switch.
IP address
planning
Device
management
IPv4 private network IP addresses are still used as
management IP addresses of the OLT and MDU
devices.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1899
To Next Page
Loading...
Need help?
General
