3. Configure the ADSL2+ line template.
Bind the preceding configured line profile and the channel profile together in the line
template with the index of 10.
huawei(config)#adsl line-template add 10
Start adding template
Press 'Q' to quit the current configuration and new configuration will be
neglected
> Do you want to name the template (y/n) [n]:
> Please set the line-profile index (1~128) [1]:10
> Will you set channel configuration parameters? (y/n) [n]:y
> Please set the channel number (1~2) [1]:1
> Channel1 configuration parameters:
> Please set the channel-profile index (1~128) [1]:10
Add template 10 successfully
4. Configure the ADSL2+ alarm profile.
You can configure the ADSL2+ alarm profile based on your requirements. For detailed
configuration, see "Configuring an ADSL2+ Alarm Template." This example uses the
default alarm profile 1 in the system.
5. Configure the ADSL2+ traffic profile.
You can configure the ADSL2+ traffic profile by running the traffic table ip command
based on your requirements.
In this example, the default profile (profile 6) is used.
6. Activate the ADSL2+ port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate all
huawei(config-if-adsl-0/2)#alarm-config all 1
huawei(config-if-adsl-0/2)#activate all template-index 10
huawei(config-if-adsl-0/2)#quit
7. Configure the upstream port.
l Configure the GIU board.
The configuration of the upstream port of the GIU board should be the same as the
configuration of the peer device.
Run the auto-neg command to set the port to work in the auto-negotiation mode.
If the port does not work in the auto-negotiation mode, change to the GIU config
mode and run the speed command to change the port rate, and run the duplex
command to change the port duplex mode.
l Configure the VLAN.
The ADSL2+ users of MA5600T/MA5603T/MA5608T-2 use the PPPoE
authentication. In this case, the smart VLAN is used to identify the users.
huawei(config)#vlan 2020 smart
huawei(config)#port vlan 2020 0/19 0-1
8. Add the service port.
All ports in slot 0/3 provide the ADSL2+ services. To add service ports in batches, run the
multi-service-port command.
huawei(config)#multi-service-port vlan 2020 port 0/2 0-31 vpi 0 vci 35
rx-cttr 6 tx-cttr 6
Step 10 Configure the SHDSL service.
The MA5600T/MA5603T/MA5608T supports the SHDSL service of multiple encapsulation
modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
5 Configuration Example of MSTP Subtending Network
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
460
To Next Page
Loading...
Need help?
General
