4
> Minimum impulse noise protection
upstream:
> 1-noProtection 2-halfSymbol 3-singleSymbol 4-
twoSymbols
> 5-threeSymbols 6-fourSymbols 7-fiveSymbols 8-
sixSymbols
> 9-sevenSymbols 10-eightSymbols 11-nineSymbols 12-
tenSymbols
> 13-elevenSymbols 14-twelveSymbols 15-thirteenSymbols 16-
fourteenSymbols
> 17-fifteenSymbols 18-
sixteenSymbols
> Please select (1~18) [2]:
4
> Will you set interleaving delay parameters? (y/n)
[n]:y
> Maximum interleaving delay downstream (0~63 ms) [16]:
24
> Maximum interleaving delay upstream (0~63 ms) [6]:
12
> Will you set parameters for rate? (y/n)
[n]:y
> Minimum transmit rate downstream (32~32000 Kbps)
[32]:
> Minimum reserved transmit rate downstream (32~32000 Kbps)
[32]:
> Maximum transmit rate downstream (32~32000 Kbps) [24544]:
8000
> Minimum transmit rate upstream (32~6000 Kbps)
[32]:
> Minimum reserved transmit rate upstream (32~6000 Kbps)
[32]:
> Maximum transmit rate upstream (32~6000 Kbps)
[1024]:
> Will you set rate thresholds? (y/n)
[n]:
> Will you set retransmission function (y/n)
[n]:
> Will you set erasure decoding? (y/n) [n]:
Add profile 10 successfully
3. Configure the ADSL2+ line template.
The configured ADSL2+ line profile and the ADSL2+ channel profile are bound together
in the ADSL2+ line template and the index of the ADSL2+ line template is 10.
huawei(config)#adsl line-template add 10
Start adding template
Press 'Q' to quit the current configuration and new configuration will be
neglected
> Do you want to name the template (y/n) [n]:
> Please set the line-profile index (1~128) [1]:10
> Will you set channel configuration parameters? (y/n) [n]:y
> Please set the channel number (1~2) [1]:1
> Channel1 configuration parameters:
> Please set the channel-profile index (1~128) [1]:10
Add template 10 successfully
4. Configure the ADSL2+ alarm profile.
You can configure the ADSL2+ alarm profile based on your requirements. For details on
the configuration, see "Configuring an ADSL2+ Alarm Template." In this example, the
default alarm profile (template 1) is used.
5. Configure the ADSL2+ traffic profile.
You can configure the ADSL2+ traffic profile by running the traffic table ip command
based on your requirements.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
5 Configuration Example of MSTP Subtending Network
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
469
To Next Page
Loading...
Need help?
General
