huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
Step 3 Create a service VLAN and add an upstream port to it.
Add upstream port 0/19/0 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/19 0
Step 4 Create service flows.
Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 300, and use traffic profile
ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
Step 5 Configure the mode of issuing VoIP services.
Run the ont voip config-method command to configure the mode of issuing VoIP services. If
the mode of issuing VoIP services is not default or omci, run this command to set the mode to
default or omci. You can run the display ont info command to query the mode of issuing VoIP
services.
In this example, the mode is default.
Step 6 Configure ONT voice service profiles.
ONT voice service profiles include the interface common profile, SIP agent profile, SIP service
data profile, POTS port profile, and digitmap profile.
l Interface common profile: saves common attributes of an ONT voice interface, including the
fax mode, fax/modem negotiation mode, and priority of the coding and decoding mode.
l SIP agent profile: saves the SIP agent information about an ONT, including the IP address
and domain name of the SIP agent server and attributes of media packets and signaling
packets.
l SIP service data profile: saves the data information about ONT voice services, including the
rights of the call waiting service, three-party service, call forwarding service, and call holding
service.
l POTS port profile: saves physical attributes of a POTS port on an ONT, including the
impedance, transmitting gain, receiving gain, and signaling type of the POTS port.
l Digitmap profile: saves the digitmap information about an ONT, including the timeout time
of the digitmap timer and the digitmap format.
1. Configure an interface common profile.
Run the display ont-mg-attribute-profile command to query the existing interface
common profile in the system. If the existing interface common profile in the system does
not meet the requirements, run the ont-mg-attribute-profile add command to add an
interface common profile.
In this example, the default interface common profile, namely interface common profile 1
is used.
2. Configure an SIP agent profile.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
613
To Next Page
Loading...
Need help?
General
