User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-5
z
PVC:
System provides 8 PVCs. Generally you can leave
this set at the default value 0. This option is also used to
create and configure new PVCs.
z
VPI:
If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default value of PVC.
z
VCI:
If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.
z
Operation Mode:
This also should be left at the default
setting
Enabled
. This enables the PVC used for the initial
connection.
z
Encapsulation:
You can select the mode LLC or VC MUX.
z
Application:
The bridged connection modes include Pure
Bridge, Static Bridge and DHCP.
I.
Pure Bridge
The setting page displayed as below will appear while you
chose Pure Bridge mode. The gray item means it can be operated
without any configuration.
To Next Page
Loading...
