User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-6
Figure 4-3 RFC2684 Bridged Connection-Application of Pure Bridge
II.
Static IP
The setting page displayed as below will appear while you
select Static IP setting mode. Please fill the corresponding field with
the IP address and network mask provided by ISP. The default
setting of route is Disable, and the Gateway IP address is 0.0.0.0.
The recommended setting is to enable default route and enter the
Gateway IP address provided by ISP.
IP Address and Subnet Mask: Entered IP address and subnet
mask provided by ISP for the WAN interface of your MT800.
To Next Page
Loading...
