8--1
DM 8 is built to be sturdy and long---lasting It has no need of any special
maintenance, though, like all other tools, it needs adjusting from time to time,
especially if not regularly looked over or used without due care.
This chapter, therefore, is intended as a guide for those who want to look after
the machine and get the most out of it for as long as possible.
The role of the operator
The person operating and maintaining the machine must follow these instruc-
tions for his own safety , as well as for the safety of other personnel, and in the
interests of machine productivity:
- check that y our own work and that of other operators is always carried out in
compliance with of the relevant safety standards; check for correct positioning
and operation of the safety devices and observe individual safety standards.
- check that the work cycle is always carried out efficiently, so as to guarantee
maximum productivity, by making the following checks:
n theoperationalstateofthemainmachineparts;
n the keenness of the blade and the coolant fluid flow;
n optimum work methods in relation to the type of material involved.
- check that the quality of the cut is right for the final product to be obtained
and that the finished workpiece presents no defects.
Maintenance requirements
- All ordinary and special maintenance must be carried out with the power shut
down and the machine i n emergency state.
- To guarantee perfect operation, all replacement parts used must be MEP
S.p.A originals.
- On completion of maintenance operations, ensure that the replaced parts or
any tools used for maintenance have been removed from the machine before
starting it up.
- Any operations carried out without due regard for the machine use and main-
tenance instructions may place the operator at risk.
- Therefore read and follow all machine use and maintenance instructions as
well as all indications present on the machine itself.
8
Maintenance and
choice of
consumables
To Next Page