Introduction and technical specifications 1---1.......................
Foreword 1---1..........................................................
Presentation of the machine 1---2..........................................
Machine specifications 1--- 2..............................................
N a m e p l a t e 1 --- 2........................................................
General Technical Data Table 1---2........................................
Dimensions 1---6........................................................
F u n c t i o n a l p a r t s 2 --- 1............................................
D M 8 M o d e l 2 --- 1.......................................................
Cutting head 2---2.......................................................
Vice 2 --- 2..............................................................
C o n t r o l p a n e l 2 --- 3......................................................
Tu r n t a b l e 2 --- 3..........................................................
Base 2 --- 4..............................................................
Safety and accident prevention 3---1................................
U s e o f t h e m a c h i n e 3 --- 1.................................................
General recommendations 3---2...........................................
Recommendations to the operator 3---3....................................
Machine safety devices 3---5..............................................
Reference standards 3---5................................................
Safety Protection against accidental contact with the blade 3---6................
Electrical equipment 3---6................................................
Emergency devices 3---7..................................................
M a c h i n e n o i s e l e v e l 3 --- 8.................................................
Noise level measurement 3---8............................................
Machine noise levels 3--- 8................................................
Electromagnetic compatibility 3---9........................................
Emissions 3---9.........................................................
Immunity 3---10..........................................................
Machine installation 4---1........................................
Packaging and storage 4---1...............................................
Anchoring the machine 4--- 4..............................................
Minimum requirements 4---4..............................................
C h e c k l i s t 4 --- 5..........................................................
Optionals to be requested with original order: 4---5...........................
O p t i o n a l s : 4 --- 5.........................................................
Balancing the cutting head 4---6...........................................
Connection to t he compressed---air supply (MA version) 4---6..................
Connection to the power supply 4---7.......................................
Description of machine operation 5---1.............................
Description of the control panel 5---1......................................
Basic instructions for carrying out a cutting operation cycle. 5---3...............
Manoeuvring the cutting head 5---3........................................
Clamping the work piece in the vice 5---4...................................
Clamping the work piece in the Automatic Vice (MA version) 5---4.............
Rapid ope ning/closing of the vice 5---5......................................
Rapid translation of the vice 5---5..........................................
Wi d t h o f c u t 5 --- 6.......................................................
Preliminary check list for cutting operation 5---7.............................
Manual operating cycle 5---7..............................................
To Next Page
Loading...