Hyd-Mech DM8 - Blade Selection Table Relating to Cutting Speed and Downstroke Speed

MEP S.p.A.
9--8 Use and maintenance manual DM 8
Blade selection table relating to cutting speed and downstroke
speed
50 / 70 40 / 50 30 / 40 30 / 40 90 / 150 90 / 300 20 / 40 80 / 800 90 / 400
14 14 14 14 14 14 14 14 14
10 10 10 10 10 10 10
6 6
8 8 8 8 6 6 6 4 4
6 6 6 6 4 4 4 3 4
4 4 4 4 3 3 3 3 3
3 3 3 3 3 3 3 3 3
10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14
10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14 10 / 14
6/10 6/10 6/10 6/10
5/8 5/8 5/8 4/6 4/6
5/8 5/8 5/8 5/8 4/6 4/6 4/6 3/4 4/6
4/6 4/6 4/6 4/6 3/4 3/4 3/4 3/4 3/4
3/4 3/4 3/4 3/4 3/4 3/4 3/4 3/4 3/4
60 -- 70 50 -- 60 15 -- 20 15 -- 20 75 -- 90 80 -- 90 25 -- 40 70 -- 80 80 -- 90
S<10 10<S<30 30<S<50 50<S<80 80<S<120 120<S<230
Dimensions of the cutting section S (mm)
Cutting material
Structural steel
Casehardened steel Steel for turning
Mild steel
High--duty cast iron Rolled steel
Spring steel Tool steel
Alloy steel
Valve steel
Stainless steel
Nodular cast iron
Copper
Soft bronze
Brass
Hard bronze
Aluminium
Plastics
Cutting speed mt./min
Blade pitch
Number of teeth per inch
Lubrication
Emulsible oil
Cutting fluid Emulsible oil
Emulsible oil
Cutting fluid
Emulsible oil Emulsible oil Emulsible oil
Emulsible oil
Emulsible oil
Emulsible oil
sq. mt./min. cut