Version 24DM
Cutting speed and choice of tools 9--7
P i t c h e s a v a i l a b l e : 3 --- 4 / 4 --- 6 .
Set:
The term set refers to the section of material removed by the blade during the
cutting operation, i.e. relating to width of cut and the offset position of the teeth
with respect to the blade back.
Standard or splayed set
This term is used to describe an alternated angling of the teeth: one to the right,
one to the left and one straight.
For general use on materials over 5 mm. thick. Suitable for cutting steels, castings
and non---ferrous hard materials.
Undulated set
Used to describe groups of teeth undulating alternatively to the right and left.
This type of set is used with very fine teeth for cutting thin pipe walls and
small---section profiles (from 1 to 3 mm).
Alternating grouped sets
These are groups of teeth angled to the right, one straight tooth, then a further
groupangledtotheleft.
This set is used for very fine teeth for cutting very thin sections (less than 1 mm).
Alternating set
This set is one tooth to the right followed by one to the left.
This set is used for soft non---ferrous materials, plastics and wood.
To Next Page
Loading...