MEP S.p.A.
7--14 Use and maintenance manual DM 8
" Slacken the TCEI head fixing screw (A) and adjust the two grub screws (B) if
the blade touches the square at its lower part. If the point of contact is at the
upper part, slacken the TCEI screw (A’) and tighten grub screws (B’) equally
until the blade is perpendicular to the square.
" Position the square on the work surface close to the front head.
" Repeat the squaring operations as for the rear head.
Orthogonality of the blade
The procedure for correcting and adjusting the blade to 0˚and 45˚ right and 45˚
and 60˚ left in order to make cuts at right angles to the fixed vice jaw is described
below.
To m a k e orthogonal adjustments at 0˚, use a workshop machinists adjustable
square or a simple 90˚ square. Operation sequence:
" lower the head;
To Next Page