2-1: Operating Instructions
2 - Operating Instructions
BEFORE OPERATING THE CTS 403 FLEX
Perform all daily and periodic maintenance as specied in Section 4 of this
Owner’s Manual.
1. Locate the van and equipment in a well-ventilated area.
The CTS 403 Flex generates toxic fumes. Position the vehicle so that the fumes
will be directed away from the job site. Do not park where exhaust fumes can
enter a building through open doors, windows, air conditioning units or kitchen
fans. If this warning is not heeded, personal injury and death can result.
2. Check the fuel tank to be certain there is adequate fuel to complete the job.
3. Connect the solution hose to the quick connect Carpet/Uph. Cleaning Solution
Outlet (see Figure 2-1).
4. Connect the vacuum hose to the vacuum inlet.
Make sure the recovery tank drain valve is closed when operating the machine.
IN ACCORDANCE WITH EPA, STATE AND LOCAL LAWS, DO NOT DISPOSE OF
WASTE WATER INTO GUTTERS, STORM DRAINS, STREAMS, RESERVOIRS,
ETC.
The penalties for non-compliance can be serious. Always check local laws and
regulations to be sure you are in compliance.
To Next Page
Loading...
