Hypertherm DynaMAX 550P - Primary operation screen

Operation
3
DynaMAX 550P/560P/575P Waterjet Pump Operator Manual 811390 51
Primary operation screen
The intensifier animation is not related to the actual stroke rate and can be moving
when the intensifier is not stroking.
3
2
4
5
7 6
1
1 Cooling mode
Touch this symbol to put the pump in cooling
mode.
2 Decrease (minus) or increase (plus) the water
pressure
3 Intensifier graphic
The intensifier graphic is animated when the
pump is on and the intensifier is engaged.
4 Output water pressure
This shows the actual water pressure in the
system.
5 Target water pressure
Refer to Set the target water pressure on
page 59.
6 Pierce-pressure mode
Touch this symbol to put the pump in
pierce-pressure mode.
7 Cut-pressure mode
Touch this symbol to put the pump in
cut-pressure mode.
Refer to Select the pressure mode on page 59
for information about pressure modes.