Troubleshooting
126 810770 Operator Manual Echion
Level
A float switch in the hydraulic fluid tank causes an alarm when the hydraulic fluid level is too low.
The hydraulic fluid level is too low.
Make sure that the hydraulic fluid level is at the top mark on the sight gauge.
A hydraulic fitting or a hydraulic hose is leaking.
Fix the leak.
Tighten the fitting to the correct torque value.
Replace the hose.
Replace the O-ring.
Hydraulic fluid was lost during maintenance.
Add hydraulic fluid. Refer to Add hydraulic fluid on page 85.
Hydraulic fluid leaks from the intensifier.
An O-ring or an energized seal spring has failed.
Disassemble the intensifier.
Disassemble the parts and look for flaws, deterioration, erosion marks, or cracks.
Make sure that the mating surfaces are smooth and clean.
If damage is found, replace the component.
To Next Page
Loading...
