Product stewardship
SC-14 810770 Operator Manual Echion
National and local safety regulations
National and local safety regulations shall take precedence over instructions supplied with the
product. The product shall be imported, installed, operated, and discarded in compliance with
national and local regulations applicable to the installation site.
Certification test marks
Certified products are identified by 1 or more certification test marks from accredited testing
laboratories.
The certification test marks are on the pump’s data plate.
Each certification test mark means that the product and its safety-critical parts conform to the
national safety standards as reviewed and determined by that testing laboratory.
Hypertherm puts a certification test mark on its products only after that product is manufactured
with safety-critical parts that have been approved by the accredited testing laboratory.
Once the product has left the Hypertherm factory, the certification test marks are invalid if one or
more of these events occurs.
The product is modified in a manner that causes danger or does not conform with the
applicable standards.
Safety-critical parts are replaced with unapproved spare parts.
Assembly is unauthorized.
An accessory that uses or generates dangerous voltage is added.
A safety circuit or other feature that is designed into the product as part of the certification
has been tampered with.
The Conformité Européene (CE) mark affixed to a product signifies the manufacturer’s declaration
of conformity to applicable European directives and standards.
Only those versions of Hypertherm products with a CE mark on or near the data plate have been
tested for compliance with the applicable European directives, such as the Low Voltage Directive,
the Electromagnetic Compatibility Directive, and the Machinery Directive.
If this product has a Declaration of Conformity, a copy (in English) is included. Refer to
Declaration of Conformity on page 173.
To Next Page
Loading...
Need help?
General
