Hypertherm Echion - Turn off the Pump: End of Day

Operation
2
52 810770 Operator Manual Echion
Operation
Turn off the pump: end of day
1. On the operator interface, touch the symbol to stop the pump.
2. Turn the primary breaker disconnect lever on the electrical enclosure door to
OFF.
3. Turn
OFF the utility water to the pump. Make sure that the water pressure gauges
show0.0bar(0kPa/0psi).
4. Turn
OFF the compressed air source.
5. Turn
OFF the electrical main (line disconnect switch). Use standard lock out–tag out procedures.
6. Remove the top cover and the front panel.
7. Clean all debris, water, and hydraulic fluid off of the hydraulic fluid tank , the intensifier
bridge , and the bottom deck .
8. Empty the dirty water container , if necessary.
Do this procedure at the end of the day.
Refer to local regulations regarding waste water. Environmental rules can apply to
disposal.
1
2
4
1
2
4
3
3