IAI PCON-CA Series User Manual

Chapter 8 Parameter
POWER CON
PCON-CB/LC
204
[74] IP address (Parameter No.140)
No. Name Symbol Unit Input Range
Default factory
setting
140 IP address IPAD mm
0.0.0.0 to
255.255.255.255
192.168.0.1
It is the parameter dedicated for Fieldbus (EtherNet/IP).
[Refer to Ether Net/IP Instruction Manual (ME0278) provided separately.]
[75] Subnet mask (Parameter No.141)
No. Name Symbol Unit Input Range
Default factory
setting
141 Subnet mask SNMK –
0.0.0.0 to
255.255.255.255
255.255.255.0
It is the parameter dedicated for Fieldbus (EtherNet/IP).
[Refer to Ether Net/IP Instruction Manual (ME0278) provided separately.]
[76] Default gateway (Parameter No.142)
No. Name Symbol Unit Input Range
Default factory
setting
142 Default gateway DFGW –
0.0.0.0 to
255.255.255.255
0.0.0.0
It is the parameter dedicated for Fieldbus (EtherNet/IP).
[Refer to Ether Net/IP Instruction Manual (ME0278) provided separately.]
[77] Overload level ratio (Parameter No.143)
No. Name Symbol Unit Input Range
Default factory
setting
143 Overload level ratio OLWL % 50 to 100 100
Do not change the default value.
[78] Gain scheduling upper limit multiplying ratio (Parameter No.144)
No. Name Symbol Unit Input Range
Default factory
setting
144
Gain scheduling upper limit
multiplying ratio
GSUL % 0 to 1023 0 (Disabling)
Gain scheduling is the function to change the gain in accordance with the operation speed.
This parameter shows the multiplying rate of the upper limit of the changeable gain.
With the set multiplying rate, the values for GS Velocity Loop Proportional Gain (Parameter
No.145) and GS Velocity Loop Integrated Gain (Parameter No.146) are changed.
Set Value Description
100 or less Gain scheduling disabled
101 to 1023 Gain scheduling enabled (Recommended value 300)

IAI PCON-CA Series Specifications

General

Brand	IAI
Model	PCON-CA Series
Category	Controller
Language	English