Quick Start Guide ~ RCON PROFINET IO Specification ~
p109
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
Initial Connection of EC
Complement
When an ELECYLINDER is connected to IA-OS for the first time after delivery,
the transportation load setup window for the initial connection should open.
In the transportation load setup, the maximum payload of the connected actuator
is set in default.
* It is a setup only for the smart tuning applicable models.
* The transportation load setting is available also for revising later.
Once the transportation load setting is transferred, the following “Information”
window should appear. Click [OK] .
(2)
The “Payload setting” window will be displayed.
Click [OK] if setting is not necessary.
(1)
When a value out of the recommended range is set, the following window
should appear.
Once the setting is complete, the “Simple data setting” window becomes
available for editing.
“Information” window
(2)
Click
“Payload setting” window
(1)
Click
To Next Page
Loading...
